Jeg plejer at brug speedfan på min htpc og tænkte at det måtte også kunne findes til linux, og ja iform af lm sensors.
jeg har nu brugt en uge på at få til at virke og bliver nu nød til at opgive og vende tilbage til vista
hvis jeg i terminalen skriver "sensors" kommer følgende.
w83627dhg-isa-0290
Adapter: ISA adapter
VCore: +1.15 V (min = +0.00 V, max = +1.74 V)
in1: +5.91 V (min = +10.77 V, max = +10.19 V) ALARM
AVCC: +3.23 V (min = +3.62 V, max = +3.87 V) ALARM
3VCC: +3.23 V (min = +1.17 V, max = +2.24 V) ALARM
in4: +0.90 V (min = +0.64 V, max = +0.48 V) ALARM
in5: +1.19 V (min = +1.38 V, max = +1.02 V) ALARM
in6: +5.20 V (min = +6.04 V, max = +0.03 V) ALARM
VSB: +3.22 V (min = +3.98 V, max = +3.46 V) ALARM
VBAT: +2.05 V (min = +3.90 V, max = +2.11 V) ALARM
Case Fan: 0 RPM (min = 332 RPM, div = 32) ALARM
CPU Fan: 0 RPM (min = 340 RPM, div = 128) ALARM
Aux Fan: 0 RPM (min = 340 RPM, div = 128) ALARM
fan4: 0 RPM (min = 340 RPM, div = 128) ALARM
fan5: 0 RPM (min = 10546 RPM, div = 128) ALARM
Sys Temp: +46°C (high = +41°C, hyst = +92°C)
CPU Temp: +51.0°C (high = +80.0°C, hyst = +75.0°C)
AUX Temp: +51.5°C (high = +80.0°C, hyst = +75.0°C)
coretemp-isa-0000
Adapter: ISA adapter
Core 0: +41°C (high = +85°C)
coretemp-isa-0001
Adapter: ISA adapter
Core 1: +41°C (high = +85°C)
når jeg så prøver at starte pwmconfig sker dette
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
Found the following devices:
hwmon0/device is w83627dhg
hwmon1/device is coretemp
hwmon2/device is coretemp
Found the following PWM controls:
hwmon0/device/pwm1
hwmon0/device/pwm1_enable stuck to 1
Failed to set pwmhwmon0/device/pwm1 to full speed
Something's wrong, check your fans!
jeg har læst alt hvad jeg kunne finde via af google, uden at det har løst noget så hjælp en eller anden......før jeg igen som det lydige får vender tilbage til microsoft folden......
